EN
37
NOTE:
• If the main unit is fastened with the
supplied screws instead of with the
holder, skip this step.
ELECTRICAL CONNECTION
IMPORTANT:
Insulate all loose wire ends with insulating tape.
Carefully check the wiring in the vehicle and
then connect the right wires to the supplied
ISO connectors.
FIG. 5
Connector/
wire
Connect to:
1 Yellow
+12 V directly from battery
(live).
2 Blue
Control of electric antenna
or power supply to antenna
amplifier. If the vehicle has a
manual telescopic antenna
without electrical actuation
or antenna amplifier, this
wire does not need to be
connected.
3 Black
Uninsulated metal surface on
vehicle body or chassis. The
black wire is the earth wire
and should be connected
before the yellow and red
wires are connected.
4 Red
+12 V from a terminal in
the electrical system that is
supplied with voltage when
the ignition switch is put in
garage mode (ACC). If the
ignition switch does not have
garage mode, connect the
wire directly to battery plus
(cont12 V). Check
before connecting the red wire
that the black earth wire is
connected to the vehicle body
or chassis.
9. Mounting plate (1)
10. Flat washer (2)
11. Spring washer (1)
12. Hex nut (1)
FIG. 1
INSTALLATION
NOTE:
• The installation method can need to be
adapted to the design of the vehicle and
supplied parts. The installation should be
carried out by an authorised service
centre or other qualified personnel.
• On the back of the removable front panel
there is a plug for all the electrical
connections between the panel and main
unit. The plug is sensitive and very
important. Do not touch it with your nails,
or any other objects like pens or
screwdrivers. The plug on the front panel
should be cleaned with a clean, dry and
soft cloth when necessary.
• After taking off the panel put it safely
away in a bag or the equivalent.
1. Check the opening in the dashboard:
– The part of the dashboard that houses
the opening must not have an angle
of more than 20 degrees. The product
will not work if it is installed at a larger
angle.
FIG. 2
2. Put the supplied rubber cap over the end of
the retaining screw.
FIG. 3
3. Put the holder in the dashboard and bend
out the fastener to fasten the holding
sleeve in the dashboard. Insert the main
unit into the holder until it clicks in place.
FIG. 4
