Marmitek TLV9600, Owner'S Manual

Page: 39 / 136

33
ENGLISH
SW OUTPUT Terminal
While recording, a pulse signal(DC 5V) is output at the SW OUT
terminal after each recording period. This terminal is usually
connected to the switch input of devices like a camera switching
unit, or a quad compressor.
1) Low
2) High
SERIES OUTPUT Terminal
During recording, when the end of the tape is reached, the output
becomes DC 5V .
SERIES INPUT Terminal
If the input becomes DC 5V for 200 msec or more,the VCR starts
series recording.
WARNING OUTPUT Terminal
1) “High”
If the error display on the display panel continues to flash, the
output becomes DC 5V. If the POWER button is pressed, the
emergency mode is released. then the output becomes 0V.
2) “Low”
If the error display on the display panel continues to flash, the
output becomes 0V. If the POWER button is pressed, the
emergency mode is released. then the output becomes DC 5V.
(NTSC) (PAL)