INVISIBLE CONTROL 2
™
5
ENGLISCH
5. FREQUENTLY ASKED QUESTIONS
x
In a few cases, the Receiver may be disrupted by interference and cannot,
therefore, pick up the signals it receives. If this is the case the red light will
be continuously illuminated than the Receiver must be relocated. This
interference is caused by equipment in the vicinity such as dimmers,
energy-saving light bulbs, IR alarms and so on. Direct sunlight can also
disrupt the Receiver.
x
Invisible Control does not work with remote controls which use High
Frequency signals (such as B&O).
x
Please ensure that the LEDs of the IR extender cable are placed correctly
to the infrared sensor of the A/V device, this has to be done very precisely.
The exact position can be found easily by shining at it with a flashlight.
x
Some IR windows from set-top and satellite boxes are very sensitive and
are easily disrupted. These devices then receive too much infrared light
and will either work badly or not work at all. Relocate the IR LED so that
less infrared light is received via the IR window.
Do you have other questions that have not been resolved by the above
information? Please go to
www.marmitek.com
6. TECHNICAL
DATA
Invisible Control 2™ module
Power:
DC 12V 200mA adapter
IR LEDs connections:
2 x 3.5 mm jack plug (mono)
Frequency range:
30-60 KHz.
IR reception range:
± 8 metres.
IR reception angle:
60° (+30°/-30° from centre).
Dimensions:
90 x 75 x 30mm
IR Extension cable
Connection:
3.5mm jack plug
IR LEDs:
2x IR LED
Length of cable:
3 metres (from plug to division 2m, from
division to LED 1m).
Specifications may change without prior notice.
