4. Install 2
–
6 ¼” bolts with 2 flat washers and nylocs. Thru the deck pad as well as the 18” and 9”
spacers and thru the deck.
5. Now you can tighten all 4 sets of bolts and nuts to 75 ft lbs.
6. Ensure you have you tire tiedowns and appropriate ramps, you are ready to load.
7. For machines over 50” wide you will require our optional 10’ and 12’ folding UTV Ramps.
Loading Instructions with Vehicle Power
1.
Set parking brake and chock tires of the loading vehicle to prevent movement while
loading & unloading, never stand between UTV and deck while loading, do not operate
vehicle or UTV under the influence of drugs or alcohol.
2.
Remove ramp/ramps from deck, make sure the ramp hooks are securely engaged on the
rear load bars of the deck.
3.
Line up ramps to match
your
machines tire width.
4.
Wear your helmet and use your seatbelt.
5.
Start vehicle and put it in low range 4x4 mode.
6.
Climb ramps at a slow steady pace
(high speed not needed or recommended).
