Page 76 / 86
Technical Notice CSO/CPO V1.1 / 10.14
9 Options
Code
Description
Output settings
O1r
On Delay for output 1
O1s
Off Delay for output 1
O2r
On Delay for output 2
O2s
Off Delay for output 2
O3r
On Delay for output 3
O3s
Off Delay for output 3
O4r
On Delay for output 4
O4s
Off Delay for output 4
Flow meter settings
fSt
Flow meter set point
ft
Flow meter delay time
fft
Flow meter on delay time during the start
fo
Flow meter offset
Level gauge settings
Lt
Level gauge delay
Restart mode after default, memory of the last fault
and replace archiving settings
Restart setting :
automatic (1) /
manual (0)
* This variable is set to 1.
This option is used to monitor: the next default, text display is frozen, the red status light
remains on, the unit remains stopped. To restart, switch off the unit (main power switch of the
unit) and then it is imperative to press the ESC key (logic controller).
Pressure transmitter settings
HP
High Pressure set point
HPd
High Pressure regulator delta = 4 bar
LP
Low Pressure set point = 2 bar
LPd
Low Pressure regulator delta = 1.5 bar
Hpo
Pressure transmitter offset for HP
Lpo
Transmitter offset for LP
HGP
Pressure treshold. Switching corresponding relay when pressure on LP sensor is at or
below the treshold.
HGD
Regulatory difference treshold. Switching corresponding relay when pressure on LP
sensor is at or over the treshold.
TZRC
Minimum working time of the compressor which switches the frost protection.
For all additional controllers, the incrementation rule governing the number after the
acronym is applied. Ex: fSt1, ft1, fft1, fo1, Lt1, etc.
