Market Forge Industries STM-E, Owner'S Manual, Page: 8 / 36

6
SECTION 1 INSTALLATION INSTRUCTIONS
INSTRUCTIONS FOR INSTALLING PAN SUPPORTS AND BAFFLES
1. Locate the mounting studs on the inside of the chamber. There are two rack mounting studs on each side.
2. Taking one pan support and positioning rack so that the pan stop is facing the rear of the unit and the wires
are facing toward the center of the unit. The pan stop is a piece of sheet metal welded to the rack with a 65
o
bend.
3.
Begin to hang the pan support by placing the rear key-way slot onto the rear mounting stud and slide the
rack until the slot sits on the mounting stud. When this is done correctly the front mounting stud will be in
position to place the front key-way slot. Slide the rack down into its correct position. See Fig. 1
.
Fig. 1.
4. After installing one pan support rack correctly, you can install the baffle. Position the baffle so that the 45o
bend is facing up and towards the front of the unit. Slide the mounting tab onto the flat bend on the pan stop
bracket. The baffle should now stay in place by itself, but in a tilted state. See Fig. 2.
Fig. 2.
5. Position the second pan support rack into the cavity and slide the other mounting tab onto the rack flat bend
while the pan support rack is not on the mounting studs. Hang the pan support by placing the rear key-way
slot onto the rear mounting stud and slide the rack until the slot sits on the mounting stud. When this is done
correctly the front mounting stud will be in position to place the front key-way slot. Slide the rack down
into its correct position. See Fig. 3.
Fig. 3.