11
MAINTENANCE
Cleaning & Preventative Maintenance
WARNING
DO NOT HOSE DOWN UNIT AS IT
CONTAINS ELECTRICAL COMPONENTS.
The Market Forge Steam-it Must be cleaned every day
as follows:
Daily:
1. Remove pan supports by lifting front up and off stud.
Pull back of pan support forward and off stud. Wash
with mild detergent and water. Rinse and dry thor-
oughly.
Figure 6
2. Wash interior of Steam-It thoroughly with mild deter-
gent and water (A). Rinse and dry thoroughly. Cylin-
der is aluminum and can pit if not cleaned properly.
Be sure to wash drain plug area if you model is so
equipped (B).
Figure 7
Weekly:
1. Remove door. (
Follow these instructions carefully as
the clearances through the portal are close and much
confusion can result if not removed in the sequence
described below
).
2. Raise the door to a fully open position and disengage
the door spring from each of the door spring studs.
Do this by counter-acting the force of the door lift
spring with one hand while working the end of the
door spring off the door assembly with the free hand.
Do this on both sides of the door assembly.
3. When the ends of the door spring have been com-
pletely freed from their respective door spring studs,
the door lift springs on either side of the door assem-
bly can easily be slipped off their studs.
Figure 8
4. Rotate the entire door assembly out through the door
opening. Pass the door handle through the opening
first and then one end of the door spring as shown.
The remainder of the door assembly will then pass
through the door opening quite easily.
Figure 9
