MARKER ONE m25, Owner'S Manual

Page: 94 / 110

Cobalt_OM_preprint_shell.fm Page 2 Wednesday, March 1, 2006 5:39 AM
MARKER ONE
PLATFORM SERIES
S
ECTION
5
5-8 M25/M27 Owner’s Manual
• Roll the top carefully around the bows and
cover with the storage boot provided.
• Your canvas is designed and intended for
short-term use only. Do not use it for storage.
• Do not tow your boat with the top in the upright
position.
Cleaning Canvas
Canvas should be cleaned regularly before
substances such as dirt and roof particles are
allowed to accumulate on and become embedded
in the fabric. The fabric can be cleaned without
being removed from the installation. Simply brush
off any debris, hose down and clean with a mild
solution of natural soap in lukewarm water (no
more than 100° F). Rinse thoroughly to remove
soap. DO NOT USE DETERGENTS. Allow to air
dry. Do not store canvas wet or in an unventilated,
moist area.
Special Cleaning Problems
For heavily soiled fabric, remove the top from the
frame. Soak the fabric for approximately 20 minutes
in a solution that has been mixed to the following
proportions:
• 1/2 cup (4 ounces) of non-chlorine bleach
• 1/4 cup of mild soap like Ivory Snow, Dreft™ or
Woolite™
• One gallon of lukewarm water (water should be
no more than 100°F [37.8°C])
Allow the fabric to soak until the non-chlorine
bleach has killed the mildew and the stains can be
brushed out with a soft scrub brush. Rinse the
fabric thoroughly in cold water to remove all of the
solution.
This may require rinsing several times. Incomplete
rinsing can also cause deterioration of sewing
threads and prohibit the fabric from being properly
retreated. Do not soak excessively, since the
non-chlorine bleach can deteriorate the sewing
threads. Allow the fabric to air dry completely.
Sunbrella may also be dry cleaned. DO NOT
STEAM PRESS OR DRY IN AN ELECTRIC OR
GAS DRYER. Sunbrella is thermoplastic, or
heat-sensitive. Excessive heat can damage and
shrink the fabric.
These methods of cleaning may remove part of the
water and stain repellency that was applied to the
fabric during its manufacture. The fabric should
receive an application of an air curing treatment
such as “303 HIGH TECH FABRIC GUARD” after it
has been cleaned.
Zippers
When zippers are new, they can be more difficult to
zip than when “used.” Zip carefully without forcing.
They will loosen with use. Keep the zippers clean.
A zipper lubricant may be used to help new zippers
and to maintain long trouble-free service. The most
vulnerable part of the zipper is where they start.
Use care when starting zipper to prevent damage.
Snap Fasteners
Fasteners should be unsnapped as close to the
button as possible. Never remove canvas by pulling
roughly on one edge of the material. This can
damage the canvas and the fasteners. To prevent
snaps from becoming difficult to unsnap, keep them
clean and use lubricants such a small amount of
Vaseline
®
, Chapstick
®
, WD-40
®
, silicone spray, etc.
The most common recommendation is to rub
candle wax or paraffin around the stud or inside the
socket. Whichever method is used, make sure you
clean up any excess so the lubricant does not stain
the canvas or any other surfaces it may contact.
WINDSHIELD
To keep the windshield clean, use a non-abrasive
glass cleaner applied with a soft cloth. Do not use
harsh detergents, solvents, chemicals or dry cloths.
These items will scratch the surface.
STORAGE AREA
Keep the storage area as clean as possible. Use a
vacuum cleaner to remove debris from the storage
area. Oil and greasy dirt will accumulate over time
and normally can be removed using soap and
water. If necessary, consult your authorized Marker
One dealer for recommendations on special
cleaning and absorption products.