E
G
E
Attach G in between E. Repeat this step 1x.
1
2
3
4
5
6
7
8
Attach A to each end of E.
Slot in the screw (C) into the hole and press it downward to secure
its position.
Tighten the screw (C) using Allen key. Repeat STEP 3 & 4 on the
other parts. The torque to tighten the screw between
receiver and leg is 22Nm to 28Nm.
Tighten the pre-instalaled screw (D) to the beam using Allen key.
Install the table top by slot in the screw (F) . Make sure the table
top is flush to the legs.
Finally, secure the table top by using self tapping screw (F).
C
A
E
G
D
E
*press downward
*flush
*MOX Pro Combi
*MOX Pro Combi (Meeting Table)
F
A
Installation for MOX Pro single is completed. Loosen
the screw (B) at the bottom of the leg to adjust the
height of the workstation and tighten it back once
reaching to the desired height.
*loosen the screw at the
bottom of the leg
F
B