E
G
E
Attach G in between E.
1
2
3
4
5
6
7
8
Attach A to each end of E.
Slot in the screw into the hole and press it downward to secure its
position.
Tighten the screw (C) using Allen key. Repeat STEP 3 & 4 on the
other side of the end leg. The torque to tighten the screw between
receiver and leg is 22Nm to 28Nm.
Tighten the pre-instalaled screws (D) to the beam using Allen key.
Install the table top by slot in the screw (F) . Make sure the table
top is flush to the legs.
Finally, secure the table top by using self tapping screw (F).
Installation for MOX Pro single is completed. Loosen the screw (B) at
the bottom of the leg to adjust the height of the workstation and
tighten it back once reaching to the desired height.
C
A
E
G
*press downward
D
F
*flush
E
*loosen the screw at the
bottom of the leg
A
F
B