31
used. Giving inputs appropriate names is simple and greatly enhances
the ease of use of your new Nº30.6, especially for occasional users of
the system. The available names are shown on page 24. To give an input
a new name:
1
Select the input you wish to rename
Note that the input to be renamed needs to be the selected moni-
tored input. The input which is currently selected to be sent out
the digital record path is irrelevant to the renaming process.
2
Press and hold the digital record select button
After a delay of approximately five seconds, the display will change
to
NAME =
(
the current name
), as shown below. If the current
name for the input is
NOT USED
, it will be abbreviated to
N.U.
This message informs you that the Nº30.6 is ready for you to
change the input’s name. (
Note that pressing and holding the
digi-
tal record select
button performs a different function than simply
pressing it momentarily, which would allow you to select a source for
the digital record path.
)
3
press the selected input button repeatedly until you see the
name you wish to use
This action will cause the display to cycle through the list of avail-
able names, with the input number appended to the end of each
name. For example, you might wish to change
CD4
to
LD4
if the
digital output of your laserdisc player is plugged into the fourth
input, in which case the display would appear as follows:
