POWDER CHECK INSTRUCTION MANUAL VERSION 1.1
5
7.
Place a case with the desired charge onto the shell plate under the powder check alarm station.
Move the tool head to bottom to verify your alarm triggers, if so, then remove the battery and
set the height of the Trigger by aligning the upper switch in the middle of the larger OD section
of the Trigger and tightening the set screw. Raise the tool head and put the battery back in,
then verify your height by lowering the tool head back onto the case filled with powder; the
alarm should not sound.
Figure 4: Trigger is not aligned with the switch (Left), Trigger is aligned with the switch completing setup (Right).
8.
Test the alarm with a case containing no powder and one containing a double charge to ensure
the alarm is working as intended.
9.
Run your press normally. The alarm will sound when it detects a nonconforming powder load.
You must check the trigger rod after each alarm and reset it below the switch or it will
continue to sound.
Troubleshooting
Refer to the knowledge base section on our website under
SUPPORT
for troubleshooting articles relating
to setup and operation.
https://www.markvii-loading.com/knowledgebase
Please contact us for technical support
Phone:
1-888-462-7577
Hours: 9:00am-4:30pm, ET, M
–
F
Tighten
set screw
to lock the
Trigger in
place
Align the
larger dia. on
the Trigger
with the
switch button
