POWDER CHECK INSTRUCTION MANUAL VERSION 1.1
3
Setup Procedures:
1.
Choose your Die Insert based on the following table and drop it into the die body:
Small Insert
Medium Insert
Large Insert
X-Large Insert
9mm
380 Auto
38 Super
40 S&W
10mm
45 ACP
357
38 Special
44 Mag
45 Colt
7.62x39
223
300 Blackout
7.62.54R
308
6.5 Creedmoor
30-06
338 Lapua
Table 1: Common calibers that work with each insert
*For calibers not listed, insert a case into the station you are going to set up your Powder Check
Alarm then thread the Powder Check Die in and leave loose. Move the Tool Head to the down
position and drop in each insert starting with the Small Insert. The correct insert will be able to
sit about 1/8” proud of the top of the die body with some die height adjustment.
2.
Place a case under the station you want to set up the Powder Check Alarm then move the tool
head to the bottom. Thread the Powder Check Die into the station until the top of the insert is
flush with the top of the die and leave loose.
3.
Slide the Powder Check Die Housing over the top of the die and make sure to push the housing
fully down onto the die body. Tighten the set screw on the back of the housing to lock in place.
Figure 1: Mounting the Electronics Housing
