10
Charge Pro™ Portable Chargers Instructions
6V COLD mode
• This mode is suitable for all 6V Flooded, GEL, AGM and spiral wound AGM
battery size found in the specifications section at low temperature.
• To select this mode, press the MODE button until LED 4 lights up. The
charging process starts automatically, LED 4 is lit.
• When the battery is being charged, charge status (LED 7) lights up to
indicate the battery charging level.
Regeneration function:
This function is designed to regenerate deep discharged batteries. It is selected
automatically if required by the battery. If a deep discharged rechargeable battery
is connected to the charger, the regeneration mode is the first mode to start.
Low charging currents are used to allow a discharged battery to reach a normal
battery voltage again. The maximum time for regeneration is 20 minutes. If no
normal battery voltage is reached in this time, the charger stops the process and
LED 6 is on.
Defective rechargeable batteries
The charger recognizes defective rechargeable batteries automatically. In this
case the selected charging program will not be started. LED 6 is on. Have your
battery tested to see if there is a problem.
Mode Select
Press the MODE button to select a mode.
Cleaning
Disconnect the battery charger from the battery and the mains voltage before
cleaning it.
Clean the outside of the product with a clean, dry and soft cloth. Do not use
aggressive cleaning agents to avoid discoloration.
TROUBLE SHOOTING
A) No LED’s Illuminate – Check AC supply and voltage output with a meter.
B) Mode cannot be changed – Disconnect battery first and then change mode.
C) Error LED is on – Check if the battery is connected.
• Check if alligator or ring terminal leads are connected to the charger
output.
• Check if plus (red) output is connected to +/positive terminal of battery
and minus (black) output is connected to -/minus terminal of the battery.
• Check if battery terminals are clean and free of corrosion.
• Check the fuse
