40
EN
• The water flows into the waste
◊ Dirt around the 6-way valve seal. —> Unscrew the 6-way valve from the lid of
the filter bowl and clean the seal.
• Leakage of the filter tank
◊ Improper sealing. —> Check the seal and replace if necessary.
• The pump motor does not run
◊ The plug out of the socket. —> Insert the plug into the socket.
◊ Missed current protector / circuit breaker. —> Switch on the circuit breaker /
circuit breaker (if the pump fails immediately if it fails again).
◊ Defective pump motor. —> Replace the pump motor.
• Sand in the pool
o If sand is new, the grain is still smaller than the specified size. —> Repeat the
rinsing process several times until the rinsing water is clean.
o Sand in a 6-way valve (rinsing remnants). —> Adjust the „Back flush“ position and
drain the water for about 30 seconds.
• Leakage of hose joints
◊ Leakage of sealing surfaces on hose connections. —> Tighten the hose spikes
with teflon tape.
Repairs on the pump can only be carried out by a specialist company.
Note: After a certain period of operation, in connection with the wear of the me-
chanical seal
between the pump chamber and the engine, you can see dripping water. It is
normal phenomenon. If dripping becomes unbearable, leave this stuffing
exchange.
Warranty conditions
Filtration was made of high quality material. All parts have been inspected
and found harmless, the warranty is valid for 24 months from the date of purchase.
Keep all purchase documents together with the instructions. Proof of purchase
will be required when applying warranty claims. Complaints of goods are governed
by the Czech legal order. The warranty covers all defects caused by manufacturing
faults or material defects. We recommend that you review its completeness when
purchasing the product. After the filtration purchase, we recommend that the
integrity of the packaging and filtering or other degradation be checked. In case of
any damage, please inform the dealer immediately. If the filter shows obvious flaws
that occur immediately after commissioning and for which equipment can not be
used, defects must be applied by the buyer to the seller without undue delay. When
defect is detected on the individual parts of the filter, complain only the faulty part.
The filter device can be installed and operated according to the instructions in this
manual.
Summary of Contents for ProStar Profi 4
Page 1: ...Písková filtrace ProStar Profi 4 6 8 Návod CZ SK DE PL EN HU ...
Page 50: ...50 1 2 ...
Page 51: ...51 3 4 ...
Page 52: ...25 let MARIMEX 1993 2018 ...
