___________________________________________________________
CKM12 User’s Manual Rev.1.1 6
Mounting the CKM12
Locate the panel mounting template supplied with the CKM12. After cutting panel mounting holes.
Place the CKM12 into panel cutout. The CKM12 mounting studs will protrude to the backside of the
panel hole. The use of silicone sealant is acceptable to provide extra sealing protection of the
CKM12 to the mounting panel. Thread supplied 10-32 nuts onto these threaded studs. Tighten to 30
In. lbs. Do not use permanent adhesive to install unit. Certain adhesives such as methacrylate will
cause cracking of the plastic enclosure. The use of permanent adhesive for installation will void
warranty of CKM12 unit. For reference to the needed panel cutout dimensions see Figure
Figure 6 - Mounting Panel Cutout Dimension
Connecting the CKM12
Connecting the CKM12 consists of plugging the unit
to the vessel’s NMEA 2000® network. The unit
can be connected to NMEA 2000 network directly to the 6 position Deutsch DT Series receptacle
molded into the unit or via use of the A3703 CKM to NMEA 2000® Adapter Cable.
Connector Pin Description
Table 2
– 6 Position Connector Pin Description