Marcy ECLIPSE HG5000, Owner'S Manual

Page: 9 / 30

ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches and Allen
Wrenches
NOTE: It is strongly recommended that this machine be assembled by two or more
people to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Insert two Guide Rods (#16) into the holes on the Rear Stabilizer (#15). Secure each
Guide Rod with one M10 x ¾” Allen Bolt (#78) and Ø ¾” Washer (#92) from the
bottom. Attach two Rubber Bumpers (#55) onto top of the two Guide Rods and slide
down to the stopper on the Guide Rods.
B.) Attach the Vertical Frame (#4) onto the Rear Base Frame (#14). Secure it with two
M10 x 2 ¾” Carriage Bolts (#90), one 4 ¾” x 2 ¾” Br acket (#25), two
∅
¾” Washers
(#92), and two M10 Aircraft Nuts (#91). DO NOT tighten the Nuts and Bolts yet.
C.) Attach the Butterfly Base (#13) to the Rear Base Frame (#14). Attach the Front Base
Frame (#12) to the Butterfly Base (#13). Align the holes and secure them together
with two M10 x 2 ¾” Carriage Bolts (#90) from the bottom, two M10 x 3 ¾” Carriage
Bolts (#89) from the side of Butterfly Base, four Ø ¾” Washers (#92), and four M10
Aircraft Nuts (#91).
D.) Attach the Rear Base Frame (#14) to the Rear Stabilizer (#15). Secure them together
with two M10 x 3 ¾” Allen Bolts (#82), two Ø ¾” Washers (#92), and one 1 5/8” x 1 ½”
Bracket (#26).
E.) Attach the Foot Plate (#17) to the Front Base Frame (#12). Align the holes and insert
the 13” Foot Plate Axle (#18) through the holes.
F.) Slide 13 Weight Plates (#45) onto the Guide Rods. Make sure the deep groves on all
Plates face down and toward the back. Insert the Selector Rod (#28) through the
center hole on the Weight Plates. Slide the Weight Selector Stem (#46) onto the
Guide Rods.
G.) Use the Weight Plate Selector Pin (#42) to select desired number of Weight Plates to
exercise. NOTE: Each Plate weights approximately 6.8kg. Please refer to the Weight
Resistance Chart on page 26.
7