Marco 1000830, Service Manual

Page: 14 / 42

SP9 ServiceManual.docx 06/02/2015 Page 14 of 42
• To enter setup mode press power and eco buttons on the front panel at the same time.
• The display will show “USER SETUP” message:
• Release the buttons now to enter the USER SETUP mode.
• To enter advanced settings (Service Setup) keep the buttons pressed until the display shows
“SERVICE SETUP” message and release them.
• In both setup modes use front panel buttons to navigate the settings:
• Power button to scroll through the functions,
• Eco button to increase set value (press and hold for auto-repeat).
8. USER SETUP OPTIONS:
The default temperature setting is 95°
The user can set the temperature of the tank. Use the navigation instructions above to change the
temperature.
NOTE: Temperature should never be set for more than 96°C as it may cause steam to be
generated during low pressure days.
Screen view Description
Default
value
Sets new tank temperature.
Range: 60
– 98.5 °C (Default 95°C)
Resolution: 0.5 °C
93.0
Sets dispense time.
Range: 0
– 99.9 seconds
Resolution: 0.1 second
For PUSH & HOLD mode set to 0 (Default).
00.0
Sets number of pauses during time dispense.
Range: 0
– 20
If machine set as PUSH & HOLD then number of
pauses has no impact on dispense.
00.0
Sets pause time (same for each of the pauses).
Range: 0
– 20.0 seconds
Resolution: 0.1 second
If machine set as PUSH & HOLD then time of pause
has no impact on dispense.
00.0
Press the
eco button to save all the values and
reboot the machine.