Marco Beverage Systems MIX PB3-1000870, Service Manual, Page: 5 / 59

Service Manual - Mix Range Nov 2016.docx Page 5 of 59
4. INSTALLATION
4.1 Mix Boiler Installation
Electrical Installation:

Electrical specification: 2.8kW-230VAC-50/60Hz

A moulded 13A IEC power cord is provided. This should be plugged into the IEC connection on the
rear of the boiler and plugged into a suitable 13A power outlet.

When installing the machine, always observe the local regulations and standards.
Plumbing Installation:

Mains water pressure required (limits): 5-50psi (35-345kPa) 0.5 – 5.0 bar

Fit a stop Valve on a cold water line and attach a 3/4" BSP male fitting, (e.g. 3/4" x 1/2" 311 or
washing machine type stop valve).

For US versions use 3/8” NPT male fitting.

Connect straight tailpiece of the hose to the stop valve fitting. Make sure that the pre-attached
sealing washer is fitted.

Turn on the water to flush any impurities, dust etc. from the inlet hose and water pipe. Allow
several litres through.

Connect right-angled tailpiece of the hose to the inlet valve of the boiler (3/4" BSP). Make sure the
sealing washer is fitted here also.

Turn on water and check for leaks.