Need Help? Contact us today (866)568-2770 or [email protected]
Installation
Step 1
– Register your SPuck
Make sure your MarCELL is registered and operating properly.
Flip your SPuck over and locate the device ID
Go to
Log in to your account
Select
” My Devices” then on the dashboard of the desired MarCELL
click the SPuck icon
Select
“Add SPuck” and follow the instructions
Step 2
– Wait for SPuck information to upload to the MarCELL
After registering the SPuck, the information will be sent to your
MarCELL unit. The LED on the front of the MarCELL will blink. This
process will take about 30 seconds and will be complete when the LED
turns back to solid green
NOTE:
If your MarCELL was not plugged in when you registered the
SPuck, the new SPuck information will be automatically updated when
your MarCELL is plugged in.
Step 3
– Select a Location and Test
Place the SPuck in the location where it will be used. Press and
release the test button. The button LED will light up and flash four
times. Quickly
The SPuck will have sent a test message to the MarCELL. If the
MarCELL successfully receives this message, it will start to blink a blue
status LED for 30 seconds. If you see the blinking blue LED you will
know your MarCELL and SPuck are communicating properly
If the LED on the MarCELL is not blinking blue, please try the following
Please be sure you have completed steps 1 and 2 and your SPuck has
been registered
Try moving the MarCELL and SPuck closer together
Repeat the test sequence