Marantz RX-7001, User Manual

Page: 20 / 82

User Guide
16
The red LED on the Receiver unit blinks when the Marantz touch
screen remote control is not being used
■ This indicates RF interference. See p. 9.
The red LED on the Blaster unit blinks when the Marantz touch
screen remote control is not being used
■
This indicates that another Marantz touch screen remote control is being used
in the proximity of the Receiver unit. See p. 13.
There is no red LED on my Blaster unit
■ Make sure the power adapter is connected properly. See p. 5.
The red LED on the Receiver unit does not blink when connecting
it to the Blaster unit
■
Make sure the power adapter is connected properly to the Blaster unit.
See p. 5.
■ Make sure the connection cable between the Receiver unit and the Blaster
unit is connected properly. See p. 5.
The Dual IR emitters are no longer adhesive
■
Replace the adhesive with a fresh piece of transparent 2-sided tape.
I cannot find the exact location of the device’s IR receiver
■
Set the Dual IR emitters to the minimal power level, and hold one of the
emitters 0.4 - 0.8 inch / 1 - 2 cm in front of the device.
Move the emitter across the front panel, and take note of when the device
reacts to the IR signals of the emitter.
When the device reacts, position the emitter in that place.
■ Check the manual for the device.
If you are still in doubt, contact your supplier or the manufacturer.
Troubleshooting