Marantz RX-7001, User Manual

Page: 17 / 82

User Guide
13
EN
2 On the Marantz touch screen remote control, choose the same
Extender ID for each device controlled by the RF Extender.
Refer to the User Guide of Marantz remote control for more information.
3 Try to operate the devices with the Marantz touch screen remote control.
The red LED on the Blaster unit will blink when the RF Extender receives a
correct command.
Note The LED of the Receiver unit will always blink when RF signals are being
received, even when the extender ID of the Marantz touch screen remote
control and the Extender ID of the blaster do not match.
The
LED of the Blaster unit will blink only when the configuration of the
Marantz touch screen remote control matches the Extender ID on the Blaster unit.
4 Repeat this procedure for every RF Extender.
How to Avoid Interference from Other Marantz remote
controls
If the red LED on the Blaster unit is blinking without the Marantz touch screen
remote control sending commands, the Receiver unit picks up signals from another
Marantz touch screen remote control on the same channel. You can solve this
problem by changing the channel.
You configure the channel on the Marantz touch screen remote control and on the
Blaster unit. Both channels must be the same. Four channels (CH from 0 to 3) can be
assigned.
1 Choose a channel on the Blaster unit by turning the CH dial with a
small screwdriver.
2 On the Marantz touch screen remote control, choose the same
channel.
Refer to the User Guide of Marantz remote control for more information.
3 Try to operate your devices with the Remote Control.
How to Use a Longer Connection Cable
When the connection cable included is not long enough to connect the Receiver
unit to the Blaster unit, you can use a longer cable (up to 20 ft / 6 m). You can
connect the Receiver unit to the Blaster unit with a standard shielded stereo audio
cable with 2.5 mm male jacks on both sides.
How to Do More