PRECAUTIONS DURING SERVICE
Initializing This Unit
Initialize this unit if you have replaced the microcomputer, one of the parts around the microcomputer, or the CD PCB.
1. Disconnect the AC plug of this unit to turn the power off.
2. Press the "
PAUSE
" and "
OPEN/CLOSE
" buttons simultaneously while inserting the AC plug to turn the power on.
3. "
INITIALIZING
" appears on the display.
NOTE
:
• Initializing the device restores settings configured by the user to the factory settings. Take note of your settings
beforehand and reconfigure them after initialization.
Service Jigs
The following jigs are used when updating the firmware
(RS232C → connector conversion PCB in this p 7P cable kit).
Order the jigs from your dealer if necessary.
00DSPK-581 : WRITING KIT (without FFC) : 1
606050028012P : 7P FFC(1.0)L=240 : 1
27 page 「VERSION UPGRADE PROCEDURE OF FIRMWARE「
PAUSE
OPEN/CLOSE
10
Summary of Contents for CD5005
