The User has the possibility to connect the device via
RS485
If the Sw is used for the first time with a new Hw Plate, will be necessary assign to the plate the
specific ID number, so to be able to put more plates in the same Network.
The ID assignment can be done asking the Sw to “Search” for the connected device (for the ID
assignment only ONE device has to be connected to the Pc Sw) and once found, the ID can be assigned
and 'stored” within the connected unit.
Once done this for more units, assigning them different Ids, then the all units can be connected in
Network and to be controlled by the same Pc sw.
If only one unit with a defined Id is connected to the remote control, in order to control it will be
enough to select as connection “with one device” and set as “ID Select” the one of the connected
unit. If more units with their different ID are connected in network , then just need to select as
Connection the “with several devices”.
The User must also set the number of the COM used to connect the device(s). When the RS485 is used
and the User want connect several devices then is important that all device have an unique ID in order
to avoid devices “overlap”.
If user not know the available COMs, then can use the button “Check” to see all COM connected on
the PC.
Summary of Contents for PDA500PF
Page 6: ...Processes Block Scheme...
