32
Kurzanleitung / Short manual
MAPAL HTC Spannfutter / HTC Clamping Chuck
NOTE
Ensure the minimum number of turns
from the clamping point to the stop
as stated in "Table 1: Minimum num-
ber of turns, minimum clamping
depth and permissible transferable
torque" (page 24) is reached. If this
is not the case, for quality reasons
stop using the HTC clamping chuck
and send it to MAPAL for repair.
NOTE
The clamping screw is not captive!
Ensure that the clamping screw is
free of dirt.
Always screw in the clamping screw
tight to the stop.
4. Turn the clamping screw to the stop with
the aid of the appropriate hex-wrench (see
"Figure 11: Clamping tool").
5. Set a torque wrench to a tightening torque
of
7 Nm
.
6. Tighten the clamping screw to the stop
with the aid of the torque wrench.
Figure 11: Clamping tool
RESULT
The tool is now fully clamped in the
HTC clamping chuck and can be
used.
