BASIC 2
35
the corresponding digital signals will be output from
the Coaxial Output jack or Optical Output jack. This
player’s digital output jacks are designed for a con-
nection to a Dolby Digital, DTS, or MPEG receiver or
decoder.
SPDIF/PCM: Choose this setting if your DVD player
is connected to a 2-channel digital stereo amplifier;
When playing a disc recorded with Dolby Digital and
MPEG audio formats, audio signals will be modula-
ted into a 2-channel PCM signal, and it will be output
from the Coaxial Output jack or Optical Output jack.
VIDEO Setup
BRIGHTNESS
Use the Up and Down arrow button to move the scroll
and adjust the brightness.
CONTRAST
Use the Up and Down arrow button to move the scroll
and adjust the contrast.
HUE
Use the Up and Down arrow button to move the scroll
and adjust the hue.
SATURATION
Use the Up and Down arrow button to move the scroll
and adjust the saturation.
Speaker Setup
DOWNMIX
Use the Up and Down arrow button to move the scroll
and adjust the saturation.
LT/RT: mix mono.
STEREO: Choose this setting, when 5.1-channel
sound playing, two channels of signals will be output
from the left and right soundtrack; when 2-channel
sound playing, stereo signal will be output.
VSS: Choose this setting, when a disc recorded with
5.1-channel sound format playing, the fictitious sur-
round soundtracks effect will be heard from the main
soundtrack. (virtual sound)
DIGITAL Setup
The audio setup options are illustrated below:
DYNAMIC RANGE:
When “LINE OUT” is selected, choose this setting to
adjust the line out ratio and get different effect. If ad-
justing to FULL, the audio signal peak value will be
the minimum; while adjusting to OFF, maximum.
NOTE:
This option will be validated when the DOWNMIX OFF.
DUAL MONO (LEFT + RIGHT)
Choose this option to setup the L and R mono output
mode; There are four modes in this option: STEREO,
MONO L, MONO R, and MIX MONO; It is mainly used in
karaoke mode.
Reference
To protect your DVD player, the interval between two
consecutive Power button operations must be above
30 seconds.
No using for a period of time, please pull out the plug
from the electronic outlet.
The player should be operated only on condition that
the type of power supply corresponds to the marking
label. Otherwise, it doesn’t work or even be damaged.
The player may not be compatible with some encryp-
ted discs.
If the player stops playback by accident, please po-
wer it on again.
So media or film may not play due to it’s format or
creation.
Features and options accords to this manual may be
changed due to technical reasons.
Specifications are subjects to change without prior notice.
Troubleshooting
Check the following guide for a possible correction to
a problem before contacting customer service.
Symptoms and Correction
No power
Connect the power plug into the wall outlet securely.
Or no press ON/STANDBY/OFF button
No picture
Verify the connection from the DVD video output to
the TV video input. Then switch TV to appropriate
mode (video 1)
Connect the video cable into the jacks securely.
Refer to your television owners manual.
No sound
Connect the audio cables into the jacks securely
Verify the connection from the DVD audio output to
the TV or receiver audio input. Then switch to the ap-
propriate source on the receiver. Refer to your audio
amplifier owners manual.
Summary of Contents for DVD-027 Basic 2
Page 37: ...BASIC 2 37 Note ...
Page 38: ...BASIC 2 38 Note ...
