8. Push Button (4) to Output “ON” position, check display to confirm.
9. Press the Voltage Knob to start the cycle runs.
The power supply will return to Normal Mode once the set cycles have
completed the operation.
Selective running of P1, P2 , P3 with Timed Cycle Program :
1. The cycle run will skip any Preset with timer set to zero.
Example 1:-
If you only want to run P1 and P2, then set the time (t3) of P3 set to 0.
Example 2:-
If want to run P3 only, then set the time (t1 and t2) of P1 and P2 to 0.
2. During a cycle run the preset in operation and the Cycle Icon
are flashing
together .
3. If all the preset timers ( t1,2,3,) are set to zero then only the Cycle Icon is
flashing. This serves as a warning of wrong setting of 3 preset timers.
Remarks :
A) ***If the number of cycle is set at zero, then the unit will run infinite cycles.
B) To exit from the Timed Presets Cycle Program during operation or the setting
with P1, P2, P3 and number of cycles, just press the Voltage Knob for 5
seconds.
C) If during any of the setting of the Timed Presets & Cycle Program, the setting
operation stops for more than one minute, the unit will return to normal
operation.
D) Previous setting time period values of P1, P2 and P3 are stored after the cycle
operation exit cycle run.
E) The values of both the Presets and the Timed Presets are retained in the unit
even after the power supply is switched off.
F) The cycle number will not be retained after the power supply is switched off or
after the preset runs completed.
