Maintenance
Section 4
4-4
Part Number 020002392
04/09
RE-INSTALLING THE PADDLE WHEEL GUARD
1. When re-assembling the rocking chute/door, the paddle
wheel guard is inserted into the opening in bin ice chute.
2. The plastic paddle wheel guard will flex in order to fit into
the opening until the guard hinge is placed into a hinge
hole on the chute.
REMOVAL OF THE GEARMOTOR
These instructions are provided as a guide for the removal of
the gear motor.
NOTE: The bin components including the agitator bar must
be removed prior to gearmotor removal.
1. Disconnect power from the electric receptacle.
2. Remove all ice from the ice storage bin of the dispenser.
3. Remove the paddle wheel pin from the paddle wheel /
agitator assembly inside the dispenser bin.
4. Remove the agitator assembly from the dispenser bin
by pushing the agitator to the back of the bin. Angle the
front of the agitator to the side. Pull the agitator forward
then out of the dispenser.
5. Remove the paddle wheel from the dispenser by pulling
the hub of the paddle wheel to the back of the bin and off
the gear motor shaft.
6. Remove the four bolts from the front wall of the
dispenser. These bolts mount into the gear motor case.
7. Remove the front from the dispenser and expose the
gear motor.
8. Disconnect the electric connector from the gear motor
wire leads.
9. Remove the strap from around the gear motor.
10. You should be able to remove the gear motor from the
dispenser.
11. To install a replacement gear motor, reverse this
procedure.
12. Plug in motor and unit.
13. Test unit.
Shipping, Storage and Relocation
Guard Hinge
Paddle
Wheel
Guard
Bin
Chute
Paddle Wheel
Guard
Paddle Wheel
Agitator
Pin
!
Caution
Before shipping, storing, or relocating this unit, syrup
systems must be sanitized. After sanitizing, all liquids
(sanitizing solution and water) must be purged from the
unit. A freezing environment causes residual sanitizing
solution or water remaining inside the unit to freeze,
resulting in damage to internal components.
Gearmotor
Wire
Summary of Contents for M-45
Page 21: ......
