Manitowoc Lincoln 2500 Series, Installation, Operation And Maintenance Manual

Page: 10 / 24

10 Part Number 20000260 Rev E 1/15
Installation Section 2
Stacking Instructions
FOR SINGLE AND DOUBLE STACK UNITS
Important
When stacking ovens, be sure to remove the bottom
flue cap from top oven.
Upper
Oven
Lower
Oven
,
Caution
If stacking configuration consists of both analog (1300
Series) and digital (2500 Series) units, always stack the
digital (2500 Series) unit on top. Incorrect stacking
arrangement may damage both ovens!
NOTE: When utilizing a double-stack configuration, stack
the ovens so that the small foot on the top oven fits into the
indentation on the top of the bottom oven.
,
Caution
If you utilize a double-stack configuration, please note
that each oven has its own disconnect switch. Make
sure that all switches are in the OFF position before
beginning maintenance or cleaning.
Mounting Instructions
Position the oven on the countertop and carefully mark
the position of the rear legs. Remove the oven from the
countertop and position the mounting rings so that the
large (center) hole is where the legs of the oven were
marked. Mark the position of the two small holes and
remove the mounting rings.
When installing on a heavy stainless steel or wood
countertop, use the four 3/16" x 9/32" drive rivets. Use a
0.218" diameter drill (7/32") and drill at least 1/2" into a
wood countertop or all the way through a steel countertop
so that the rear legs are in the large holes in the mounting
ring.
Position washers to rear legs, anchor them to
countertop using screws provided.
,
Caution
Install this unit in the most convenient locations for
ease of cleaning, maintenance, and general operation.
Avoid installing in locations with drafts, close proximity
to grease or vapor-producing appliances or other high-
ambient heat equipment.