2-3
Section 2
Component Identification & Removal
Water Curtain
The ice curtain is designed to keep the spraying water from
escaping the evaporator compartment. Removal of the bin door
is not required, but enhances access.
1.
Grasp one end of the ice curtain and lift up.
2.
Pivot water curtain and disengage remaining end.
3.
To re-install into ice machine, grasp one end of the water
curtain, install one end, pivot the opposite end and pull
down into position. Make sure tabs are secure in grooves.
Ice Chute
The ice chute is positioned over the spray nozzles and allows the
ice to easily fall into the bin. It must be firmly positioned on the
Water Distribution Assembly, with the front edge inside the
water trough or the spray nozzles will not be aligned with the
spray holes, and spray water will fall into bin.
1.
Grab protruding spray holes on one end and lift up.
2.
Pivot ice chute and remove.
3.
To re-install ice chute, grasp protruding spray holes and
position over Water Distribution Assembly. Make sure rear
supports are over Water Distribution Assembly, and front
edge is inside of water trough.
WATER CURTAIN
ICE CHUTE