A–1
1814E with FILTERQUICK™ SERIES ELECTRIC FRYER
APPENDIX A: BULK OIL INSTRUCTIONS
A.1.1 Bulk Oil Systems
Bulk oil systems have large oil storage tanks,
typically located in the rear of the restaurant, that
are connected to a rear manifold on the fryer.
Waste oil is pumped from the fryer, via a fitting
located on the rear of the fryer labeled DISPOSE
(see Figure 1), to the disposal tanks and fresh oil
is pumped from the tanks, thru the fitting located
on the rear of the fryer labeled FILL, to the fryer
(see Figure 2). Connect the bulk oil connections
to plug located on the rear of the fryer (see
Figure 3). The wiring diagram is located on the
next page.
It is imperative that the fryer system be
completely power cycled after changing any
fresh or waste oil settings.
Figure 1 Figure 2
Figure 3
The 1814E with FilterQuick
™
fryers, equipped
for use with bulk oil systems, have an onboard
fresh oil reservoir that may or may not be
supplied by the bulk oil provider. For fryers
batteries with two or more vats, remove the cap
and insert the standard fitting into the jug with
the metal cap resting on the lip of the jug. The oil
is pumped in and out of the jug or saddle
reservoirs on singles, through the same fitting.
(see Figure 4).
Figure 4
The momentary switch used to reset the ATO system
is also used to fill the jug or saddle in a fresh bulk oil
system. After clearing the TOP OFF EMPTY
display, pressing and holding the momentary switch,
located above the JIB, allows the operator to fill the
jug or saddle from the bulk oil storage tank (see
Figure 5).
To fill the jug, press and hold the JIB reset button
until the jug is full, then
release.*
NOTE: Do NOT overfill the
jug or saddle.
For instructions on filling the
vat from bulk, see the
FilterQuick Controller Manual
Section 1.9.8.
* NOTE:
It takes approximately twelve seconds from the time the fill JIB button is pressed until the
fresh bulk oil pump starts. It may take up to 20 seconds before the level in the JIB begins to
rise. Typically it takes approximately three minutes to fill the JIB. It takes approximately
two minutes to fill a full vat.
Fresh Oil
Connection
Waste Oil
Connection
WARNING:
Do not add HOT
or USED oil to a
JIB or fresh oil
saddle reservoir.
Bulk wiring
connection
Figure 5