50960025/CP0514
16
PRINTED IN U.S.A.
SAFETY
24. The platform must be fully lowered for personnel
to enter and exit. Personnel must not climb on
any part of the forklift in attempting to enter and
exit.
25. Any harness, body belt, lanyard, or deceleration
device that has sustained permanent deformation
or is otherwise damaged must be replaced.
26. Modifications to the platform that are detrimental
to its safe use are prohibited.
Wireless Remote Battery Replacement
1.
Remove the four screws from the cover of the
wireless remote.
2.
Open the cover to gain access to the batteries.
3.
Remove the batteries from their holders.
4.
Install the replacement batteries in the holder tak-
ing care to position the battery terminals as shown
in the diagram at the bottom of the battery holder.
5.
Replace the cover and install the screws to secure
the cover in place.
Work Platform Design Requirements
(Per ANSI/ITSDF B56.6-2005, Sec. 8.24)
1.
A platform floor having a slip-resistant surface
located not more than 8 inches (200 mm) above
the normal load-supporting surface of the forks.
WARNING
Use ONLY an approved work platform for ele-
vating personnel.
NEVER move the machine with the work plat-
form in a raised position or with personnel on
board.
NEVER tilt the platform forward, rearward, or
to the side with personnel on board.
ALWAYS engage the PWP System and follow
the Mandatory Work Platform Safety Rules
when elevating personnel.
Work Platform
Switch
PWP
Remote
Shutdown
Switch
Electrical
Connection
Remote Shutdown Switch
with Coiled Wire Connector
Wireless Remote Shutdown Switch on MT10055
PWP
Remote
Shutdown
Switch
