Manitou 160 ATJ E3, Instruction Manual

Page: 134 / 160

3-22
C3
C3 - FRONT AND REAR WHEEL REDUCER OIL LEVEL
CHECK
Set the platform on a horizontal surface with the engine off.
- Check the oil level in each of the front and rear wheel reducers.
- Set the level plug 1 (Fig. C3) horizontal.
- Remove the level plug; the oil should be flush with the hole.
- Add oil, if necessary (see the LUBRICANTS section), via the same hole.
- Screw the plug back in tightly 1 (Fig. C3).
- Perform the same operation on each of the rear wheel reducers.
C4 - TIGHTENING THE WHEEL NUTS
CHECK
- Check the tightness of the wheel nuts (Fig. C4).
Failure to observe this instruction may cause the wheel pins to be damaged
and break, as well as the wheels to deform.
C5 - EMERGENCY PUMP
CHECK
- Switch off the engine.
Check that the emergency pump is operating correctly by pressing the switch on the side of the
base control box or the basket control box.
- Perform an arm lowering movement (example...)
You must not use the lifting platform under any circumstances if the pump
is not working.
C6 - TELESCOPE ADJUSTMENT
CHECK
- Check the tightness of the 16 nuts on the telescope skids Ref.1 (Fig. C6/1 and C6/2).
Failure to observe this instruction may result in loss of the skids and damage
to the telescope.
WHEEL NUT
TIGHTENING TORQUE
FRONT WHEELS
34 daN.m
± 15 %
REAR WHEELS
34 daN.m
± 15 %
C4
C6/1
C6/2
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1 1
647414 EN (27/05/2015)