13
HINT:
Enter your postcode with the number buttons by
pressing the correct button on the remote a number of
times to produce the required letter (printed on each
button), or number, in the same way as ‘texting’ with a
mobile phone. For example, for an ‘S’, you would press
the
button four times. If you make a mistake, the
button deletes the last character entered.
Press
or
to highlight the “Next” box and then press
to
display the next installation screen. If after doing this you lose the
picture on your screen press
to return to the first installation
screen using the default resolution of 720p (supported by all HDTVs).
The signal check screen shows the strength and quality of the
Freesat signal received from your satellite dish. The signal lock is
successful if both LNB inputs are receiving a valid signal. If the
second input is not receiving a valid signal, you will be able to
proceed with installation but recording functions of the receiver
will not work correctly and a warning message will display. If
the first input is not receiving a valid signal, the signal lock will
fail and you will not be able to proceed. Check the satellite dish
connections at the back of the receiver (switch the receiver off
and reconnect the cables if necessary). If the connections are OK,
consult your retailer or installer.
When the signal lock shows “Successful”, you can continue to tune
in the receiver. Press to proceed.
Enter your postcode using the number buttons on the remote control.
You do not need to enter a space. Press the button when you have
entered your postcode, and then press again to proceed.
