6
adjust the antenna. See following options.
Option 1
If you know at least one network between channel 21 and 69 is used in your area follow
below setup.
6.
Realign the antenna for maximum Level/Quality reception. When aligned correctly to
the transmitter, the Signal Level and Quality should increase. On the Quality, 6 is
minimum number for a stable image. If the Level does not increase, it means that you
have selected an incorrect network number, or the transmitter is too far from your
antenna.
7.
Once you have achieved the maximum Level / Quality, fix the antenna position firmly.
8.
Press
EXIT
.
9.
Go to
Menu
/
Setup
/
Service Setup
/ enter
PIN
/
Full Scan Replace Existing
Services.
10.
Press OK to start scan.
Option 2
You are able to receive national channels in analogue, but have no idea what you can
receive in digital quality or if you are certain that you can receive additional channels,
but you do not know which network is used for these channels, we advise that you do
the following.
Install a UHF antenna with high gain (at least 15 dB) and connect it to the ANT input of
the receiver. Adjust the antenna so it is in the same position as the previous one and
start an automatic channels search. (Go to
Menu
/
Setup
/
Service Setup
/ enter
PIN
/
Full Scan Replace Existing Services
).
If you find channels that you were unable to receive with your previous antenna, simply
replace it with the new one. Otherwise align the antenna 1/8 of a turn and start another
automatic search. Continue this process until you find at least a few channels.
1.
Select one of the new channels received.
2.
Go to
Menu
/
Setup
/
Service Setup
/enter
PIN
/
Manual Scan.
3.
At the bottom of the screen, observe the signal level and quality.
4.
Align the antenna to optimize the level and quality (quality must be at least 6).
5.
Fix the antenna firmly.
6.
Press
Menu
to go back to the previous menu.
7.
Perform an automatic search (Go to
Menu
/
Setup
/
Service Setup
/ enter
PIN
/
Full Scan Replace Existing Services
).
EDITING THE CHANNEL LIST
There are two ways of editing the channel list. The first is to create Favourite channels.
1.
Go to
Menu
/
Setup
/
Service Setup
/ enter
PIN
/
Manual Scan
.
2.
Press Left/Right key to select the channel number
of the UHF network that transmits digital channels
(see channels list on page 13).
3.
On
Tx Mode
, select
2K
with the Left or Right key.
4.
On
Guard Interval
, select
1/32
with the Left or
Right key.
5.
Wait for a few seconds and monitor the
Level
and
Quality
graphs.
