10
Fig.B
Fig. D
Fig. C
6.2 Drawing steam
A jet of steam, which can be used to foam milk or to heat other liquids, comes out of the steam drawing
spout as follows: by raising or lowering the lever you attain the maximum flow (the lever stops in the
maximum position. To stop the flow of steam, place the lever back in its original position).
The steamer must be used with care: the contact of the skin with the steam spout or with
the jet of steam itself can cause serious burns. Grip the anti-burn sheath to change the
position of the steam drawing spout. Never aim the jet of steam at persons or at objects
which do not have to do with the use as described in this manual.
Note: Before using the spout for drawing steam, drain out into the tub any condensation which may
have formed
in it. After using the spout, clean it properly with a moist cloth, and if necessary
discharge any residue remaining inside it into the tray.
6.3 Drawing hot water
Hot water is drawn by the appropriate spout
5
and can be used to prepare infusions, tea, camomile
tea, to heat cups, to add water to an espresso and to obtain American-style coffee, and so on. Use the
hot water lever
7
to draw hot water (lower, raise or move sideways the lever).
6.4 Cup heater (optional)
The cup heater is used to increase heating of the upper cup support surface. Switch on to activate or
deactivate the cup heater by the rocker switch positioned on the top of the cup heater.
6.5 Setting temperatures
1.
This machine is equipped with groups with elements built in and two boilers, one brew
boiler and another service boiler for steam and hot water. Every single temperature can be set
up individually, so you can personalize your machine as much as you can.
2.
When the machine is on the display you will read some information Fig.B. Starting from the
left to the right you will read the temperature of each group 1,2,3 and 4, and pressing the
button Fig.B you will enter in the second page Fig.C where you can change the measure units
F/C°, switch on and off the machine. If the machine is equipped with 2 groups all the
temperatures will be shown in the first page, for the 3 groups in this page you can set also the
steam temp and if it’s 4 groups also the brew boiler.
3.
To set up a temperature, press a correspondent icon to select one of the groups or one of
the two boilers, once pressed a page like Fig.D will appear, with +/- you will increase or decrease
the temperature, with green button on the right you will save and exit. It’s also possible to
exclude one or more elements just pressing the left icon.
