Cayenne
™
Series
V.121806
4. Installation
4.1 Installation
Instructions
Inspection
Carefully inspect for signs of damage in transit. If equipment has been damaged in transit, notify the
Freight Forwarder immediately. M&R is not responsible for damage that occurs during transportation.
Components
-Flash cure
-Quartz heating elements
-Signal cable
-Assembly hardware
-Optional sensor assembly (for presses not pre-wired for PLC integration)
Step 1
Install the two rear leveling legs with adjustment handles (1)
and leveling pads (2) as shown. The threaded studs with
adjustment handle (1) are screwed into the threaded hole
on the lower leveling angle brackets on the chassis, and
then into the metal leveling pad (2) which rests on the floor.
Step 2
Unlock the front frame holder assembly on the print head
and move it into the locked upright position.
Step 3
Standard Series Press
Move the print carriage and front proximity bracket back
towards the center of the press. Position the flash cure over
the pallet as shown.
Z-Series Press
Move the print carriage back towards the center of the
press. Position the flash cure over the pallet as shown.
12
M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA
Tel: +630-858-6101 Fax: +630-858-6134
www.mrprint.com
