1. HEAT
RIGHT, Press the “HEAT” key, the control lamp “HEAT” lights up.
The preset power stage “5” is selected and the device turns on.
(Power stages: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10)
With the “+”/ “-” keys, you can change the settings at any time in
a range from 1-10.
LEFT, Press the “HEAT” key, the control lamp “HEAT” lights up.
The preset power stage “4” is selected and the device turns on.
(Power stages: 1, 2, 3, 4, 5, 6, 7,)
With the “+”/ “-” keys, you can change the settings at any time in
a range from 1-7.
2. TEMP
Press the “TEMP” key, the control lamp “TEMP” lights up. The preset
temperature stage “120°C” is selected and the device turns on.
(Temperature stages: 60, 80, 100, 120, 140, 160, 180, 200, 220 and
240°C)
With the “+” / “-” keys, you can change the settings at any time in
a range from 60 to 240°C.
3. LOCK
In the working state or in the standby mode, press and hold the child
lock button for three seconds, the buzzer sound, the two digital tube
simultaneously flash LOC (machine) into the child lock state, Repress
the child lock 3 seconds to unlock the unit, or cut off the power and
plug in again to unlock the child locking.
4. Timer-function:
After select of the operating mode (HEAT stage or TEMP stage), press
the “TIMER” key. The control lamp “TIMER” lights up and the cipher
“0” appears on the LED display. By pressing the “+” / “-” keys you will
be able to select the operating time in increasing 5 minutes (up to
180 minutes maximum), reducing 1 minute.
The time will be counted down in minute steps, where upon the
display returns to the prior status (HEAT, TEMP).
Utensils suitable for this appliance
Compatible Pans:
Steel or cast iron, enamelled iron, stainless steel, flat-bottom pans/
pots with a base diameter of 15 to 24 cm.
Non-compatible Pans:
Heat-resistant glass, ceramic container, copper, aluminium pans/pots.
Rounded-bottom pans/pots with a base of less than 15 cm.
Maintenance
•
Clean after each use. Disconnect plug and wait
until the unit has cooled down. If the pots/
pans are used without being cleaned, as this
may result in discoloration or stains. Do not
use fuel, paint thinner, scrubbing brush or
polishing powder to clean the induction stove.
• Wipe down the unit using a dish washing agent
and a damp cloth. Use vacuum cleaner to suck
up dirt from the air intake and exhaust vent.
• Never run water over the unit (if water
gets inside it may cause malfunction).
Once the time is up, an acoustic signal sounds and the unit
automatically goes into standby mode. If you want to cancel the
TIMER function, simply press the ON/STANDBY key to switch off and
repeat to restart.
GB-6
GB-7
