Mandik VBM-V Series, Instruction Manual

Page: 8 / 12

7
Blinking clock symbol means that the time was not set or the remote control was not used for more than 48 hours.
should be pushed for more than 2 sec → will be displayed and the actual time and day (SEL 00:00 DAY1 (Mon))
should be pushed shortly → minutes will start blinking → by using the , the actual time
can be set → confirm by → clock will start blinking, which should be set in the same manner as minutes and
confirmed by the → DAY1 will start blinking and the weekday may be set in the same manner as the hour →
push and confirm settings of the actual time and day.
DAY1 - Monday, DAY2 - Tuesday, DAY 3 - Wednesday, DAY4 - Thursday, DAY5 - Friday, DAY6 - Saturday, DAY7 - Sunday.
CLOCK button should be pushed for a shorter time than 2s.
should be pushed for longer than 2 sec → SEL will be shown and the actual time → and select PRO
→ confirm by → select ON or OFF (turn time schedule off or on) → select ON → push → large
digits on the display will show PR01, small digits will show the beginning of the first time interval → push and
the time 00:00 will start blinking, set the time then by → confirm by → DAY1 for
weekday selection will start blinking → select the weekday by → confirm by . Then by using
the , select and set the requested value → confirm by .
Monday - Sunday:
Pr01: 07:00 50%
Pr02: 17:00 100%
Pr03: 22:00 25%
Space controller may be pre-programmed for the user by request in the factory e.g. the number of ventilation stages, ventilation
intensity settings in grades or percentage, setting the time for PARTY mode turn off, setting the grades for 2...10V DC, etc.).
WITHIN STANDARD SETTINGS, 8 TIME SCHEDULES MAY BE SET (PR01. . . PR08)
– REG2 Space control
– N230-24 connecting unit for the VBM-V box
– servo drive for LMV-D3 air flow controller
– connecting cable of the supply voltage 1x230V/50Hz with EURO plug
REG2 connecting terminal