Rolling Code Transmitters - Series "100"
Rolling Code Transmitters - Series "100"
Specifications and Programming Instructions
Specifications and Programming Instructions
➢
Matching the Transmitter to the On-Board Radio Receiver RADIORE101 or to the
External Universal Radio Receivers RADIORE901/901A/901B
Note:
For RADIORE102, consult TN1028 for pairing instructions.
To MATCH the Transmitter to the Receiver:
Once the Transmitter has been correctly programmed according to instructions
found on p. 1-2, select the Receiver of choice, refer to Figure 1 or Figure 2 and
follow the steps below:
For RADIOEM101/102/103/104:
1. HOLD the Receiver's
LEARN
button until the
LED BLINKS
for
approx. 2 sec. (frequency of 1 sec. ON / 1 sec. OFF).
2.
To program in 3-Button Mode:
On the Transmitter, HOLD any button
until the Receiver's
LED
stops blinking .
3.
To program in 3 x 1-Button Mode:
On the Transmitter, HOLD the
desired button that you want programmed until the Receiver's
LED
stops blinking .
For RADIOEM144:
1. Adjust the Transmitter's rotary dials to the desired positions to permit for
the proper door selection.
2. HOLD the Receiver's
LEARN
button until the
LED BLINKS
for
approx. 2 sec. (frequency of 1 sec. ON / 1 sec. OFF).
3. On the Transmitter, HOLD any button until the Receiver's
LED
stops
blinking .
Note:
You can match 1-Button, 3-Button, 4-Button AND 144-Door Transmitters
with the same Receiver. Mix and match any of the Series 100 Transmitters
accordingly for your application (ordered separately). One Receiver will accept
up to 50 Transmitters.
To DELETE ALL Transmitters from the Receiver's Memory:
1. HOLD the Receiver's
LEARN
button until the
LED BLINKS
for approx. 10 sec. (frequency of 1/3 sec. ON /
1/3 sec. OFF).
1-800-361-2260
3
TN1054 REV 2 - 2022/01/24
Figure 1 - RADIORE101
(ECB BOARD070 /
RADIOKIT005)
Figure 2 - RADIORE901
(RADIORE901A/901B)
LED (RED)
LEARN
BUTTON
ANTENNA
LED (WHITE)
ANTENNA
LEARN
BUTTON
