Man iSea, Operating Instructions Manual, Page: 82 / 172

Control and operation
80
Read this manual carefully before starting any work!
This is particularly applicable to the chapter “General Safety Instructions”
and the respective safety instructions in the chapters.
Alarm page
In case of a warning message, an alarm or a signal error, the internal alarm buzzer is activated and the
display generally immediately changes to the alarm page (apart from when the “Emergency drive” mode is
active). Newly occurring error message are shown flashing.
The operator has the option of switching between registers (Engine/Emission/Digital I/O) on the display.
On “twin engines“ displays, additional two registers for portside and starboard are displays.
The following values can be queried:
on “Engine” - page
S
Type (warning/alarm/signal error)
Under the „Type“ button, the ACK
(acknowledgment) function is stored
S
Description
S
SPN and time stamp
S
Values (actual value)
S
Limit values (extreme value)
A permanent tone is sounded upon occurrence of
an alarm on the engine page.
on “Emission” - page
(only in the case of engines with aftertreatment system)
S
Type (warning/alarm/signal error)
Under the „Type“ button, the ACK
(acknowledgment) function is stored
S
Description
S
SPN and time stamp
S
Values (in %)
The system monitors the following
emissions-related faults:
S
Fill level of DEF/AdBlue®/AUS32/AUS40
S
Quality of DEF/AdBlue®/AUS32/AUS40
S
Failures in aftertreatment system
An intermittent sounds is emitted in case of an
alarm on the emission side.
For emission-related alarms, see also page 90.
on ”Digital I/O“ - page
(only with 7 inch - optional)
S
Description
S
SPN und time stamp
S
Horn OFF
S
Limit values (extreme value)
S
Activate output 2 (the alarms are only displayed
on the configured device)
Tip for users
On the 7 inch display, an additional buzzer can be connected to the digital output 1 for better acoustic de­
tection and is controlled analog the internal buzzer.