Mammuth SP50HEL, Installation And Operating Instructions Manual

Page: 13 / 25

14. Place the work piece always perpendicularly under the cylinder.
15. Always make sure that your feet are positioned steady on the ground, so you cannot fall.
16. Use the right tool with the correct speed, do not force the machine to carry out a task for
which it is not meant to be.
17. Remove loose objects and unnecessary workpieces from the workplace, before you start
the machine.
18. Check the direction of rotation of the electric motor of the press, this is indicated with
an arrow on the electric motor.
19. For maintenance and repair work, always unplug the press from the power supply and
work with a minimum of two persons.
20. Release the pressure of the system at all times, before maintenance or repair work.
21. Be sure to use prescribed PPE (personal protective equipment) when you are going to be
working with the shop press, these are the following: safety glasses, protective clothing,
gloves, safety helmet, safety shoes and hearing protection.
22. Please be aware at all times that you are don’t put body parts between the moving parts
of the shop press they may get pinched, this can lead to very serious injuries.
23. Never use the shop press near explosive and/or light-flammable substances and/or
gases.
24. Check the press regularly for broken parts, leaks and check the operation of the press,
stop immediately upon detection of possible defects and let the machine checked and/or
repaired by a specialized company/mechanic. Also perform the periodic
audits/inspections as described in the standard periodic maintenance protocol, for
maintenance and repair work, go to your nearest Mammuth-dealer. Use only original
Mammuth parts for the replacement of defective parts.
25. Failure to these instructions may cause personal injury and/or damage to materials.
26. The pressure relief valve is set in the factory, it is strictly forbidden to change these
settings.
27. It is strictly prohibited to make constructive changes to the press/to the press or to grind,
weld, etc..