Introduction
There are two models of the Polaroid Pack Film Holder depending on the type of camera.
RZ67: Polaroid Film Pack Holder HP702
RB67: Polaroid Film Pack Holder HP701
The area produced by the Polaroid instant print is approximately 7x7cm.
Attaching the Polaroid Pack Film Holder to the RZ67 Camera Body
1. Align the Revolving Ring’s orange circle, found at the back of the camera body, with the upper
Index Mark on the camera body.
2. Hold the Polaroid Pack Film Holder so that its orange circle is at the same position as the one on
the camera’s Revolving Ring.
3. Place the Polaroid Pack Film Holder on the back of the camera.
4. Be sure that the camera’s four Mount Pins fit into the four holes in the Polaroid Pack Film Holder.
5. Secure the Polaroid Pack Film Holder to the camera body by moving the holder’s Lock Lever to its
lock position.
6. Set the camera’s R-M Lever to its normal, white square, position.
7. Turn the Polaroid Pack Film Holder’s ISO Dial to the speed of the Polaroid film.
8. Remove the Dark Slide and store it in the Polaroid Pack Film Holder’s Dark Slide Slot.
Attaching the Polaroid Pack Film Holder to the RB67 Camera Body
1. Detach the Revolving Adapter from the camera body by pulling the R-Lock Lever out and down.
2. Place the Polaroid Pack Film Holder on the back of the camera
3. Be sure that the camera’s four Mount Pins fit into the four holes in the Polaroid Pack Film Holder.
4. Secure the Polaroid Pack Film Holder to the camera body by R-Lock Lever to the body side.
5. Remove the Dark Slide and store it in the Polaroid Pack Film Holders Dark Slide Storage Slot.
The shutter can be released even if the Dark Slide is in the Polaroid Pack Film Holder.
