MAM MFE80, Instructions For The Use And Maintenance

Page: 27 / 42

26
www.mamforni.it
D GB
Abbreviation Description
ON / OFF START BURNER SWITCHING ON
Push button to switch on and off the burner
• on /off function
AUTO START BURNER SWITCHING ON IN AUTOMATIC CONDITION WITH CHECK OF THE T° THRESHOLD.
Through this push button you select the automatic condition of the heat regulation when getting to the pre-set temperature
programmable by means of the + / - push buttons.
In AUTOMATIC condition the writing “AUTO” displays on the multifunction display. Operating on the + / - push buttons the
operator can increase or decrease the working temperature of the oven in °C. This value can always be visualized up on the
left of the display.
MAN MANUAL CHECK OF THE FLAME
Pressing this push button the operator can activate the MANUAL condition function and a symbol representing a “hand” will
display up on the left.
Under this condition the operator can adjust manually by means of the + / - push buttons (always operating) the flame
intensity that will be displayed with led light bars that light up according to the flame intensity.
BOOST BOOST MAXIMUM TIMED POWER.
Pressing this push button the operator can activate the maximum power of the burner, with relative display of the writing
“Boost” on the multifunction display (up on the left), for the time that can be set by means of the + / - push buttons from a
minimum of 1 min. to a maximum of 9 min., displayed next to the writing boost. During this function the + / - push buttons
will increase or decrease the time constantly. The hour glass symbol is next to the operating cursor. Once the time has passed
the previous conditions will be restored. The time that was pre-set in the previous cycle is proposed again in the following cycle.
This temporary function can be activated both in automatic and in manual condition.
R RESET OF THE BURNER BLOCK
This push button is used to unblock the burner in case the flame does not light on.
INPUT OF PROGRAMMED AUTOMATIC STARTING
Pressing the push button (in the middle of the display) the flame symbol beside the clock will display; while up on the right
the residual time (in hours/min) for the delayed start will display. Acting on the + / - push buttons the operator increases or
decreases of 0,5h to a maximum of 48h and a minimum of 0.5h. 10 seconds before the starting, a buzzer will warn with a beep
at any second for 3 seconds after which it will become a continuous sound until the starting. The preset time in the previous
cycle will be proposed again in the next automatic cycle.
+
INCREASE THE DISPLAY VALUE
Pressing the push button the operator will increase the value in the display set out by the previously activated function. The
push button increases slowly and after some seconds the value will increase exponentially. Once you have released the push
button, the value will be stored without the necessity of confirming it. When the terminal is switched off but powered, the push
button increases the current time (up on the right of the display).
-
DECREASE THE DISPLAY VALUE
Pressing the push button the operator will decrease the value in the display set out by the previously activated function. The
push button decreases slowly and after some seconds the value will increase exponentially. Once you have released the push
button, the value will be stored without the necessity of confirming it. When the terminal is switched off but powered, the push
button decreases the current hour (up on the right of the display)
ALARMS Interrupted probe:
• The burner works in manual condition only – ( passing automatically from the automatic to the manual condition)
• Visualization on the display – PROBE OFF or coherent icon.
Blocked burner:
• Visualization on the display: see the crossed icon