OPERATION INSTRUCTIONS
There are 3 controls that require your attention.
The first is the valve on the cylinder,which will be used to turn ON and OFF the gas supply.
The second is the gas control knob with a dial which has 3 position marked on it.
This control knob is located on the top end of the heater(see figure 1)
The third is the piezoelectric ignition button next to the gas control knob.
Pressing this button will generate a spark on the pilot burner thus igniting the gas to the
pilot burner. The pilot and centre burner should remain alight.
You may adjust the heater setting to Low/Med/High as required.
CONTROL BUTTON:
GAS CONTROL:
1. LIGHTING INSTRUCTION
A. The heater has three settings. Lighting position
（
Pos.1
）
Minimum position (Pos.2);
Medium position (Pos.3) Maximum position (Pos.4).
B. Turn on the gas on the container.
2. LIGHTING:
Use one hand Press down the control button for 10 seconds, at the same time press down
the piezo igniter key with thumb finger of another hand. Continue this procedure until pilot
is ignited. Approximately 20 seconds later release the control button. At the moment if pilot
is ignited, it means that the heater is at its minimum position. If pilot flame goes out, please
repeat this procedure.
13/24
