Figure.3
c. Regulate the gas flow pressure according to the thermal power desired, by turning the
wheel of the pressure reducer anticlockwise to increase the pressure or clockwise to
decrease.
d. If the flame ignites but after few seconds the heater locks, the RESET control lamp
lights up. Wait one minute, then unlock the heater by pressing the RESET button and
repeat the starting operations.
e. Contact your supplier should any problem continue.
3.1.2 IGNITION / Manual ignition
a. Turn the power switch to position I and check that the fan starts running correctly.
(Fig 2.)
Figure.2
b. Push the gas valve button and push repeatedly the piezoelectric lighter until the flame
lights up. (Fig 3-4)
Figure.3
Figure.4
c. As the flame lights up, keep the valve button pushed for 10 seconds approx. Should the
heater stop when the valve button has been released, wait one minute and repeat the
starting operation keeping the valve button pushed for a longer time.
d. Regulate the gas flow pressure according to the thermal power desired, by turning the
wheel of the pressure reducer anticlockwise to increase the pressure or clockwise to
decrease.
e. Contact your supplier should any problem continue.
CAUTION
If ignition is difficult or irregular before repeating the ignition operations make sure
that the fan is not locked and the air inlet and outlet are unobstructed.
17/20
