www.malmsten.com
Malmsten AB • www.malmsten.com
+46 44 28 71 00 • [email protected]
v.47
-23E
INSTALLATION
8
Swimming Pool Lift
DEVICE
i-swim2
MODEL
Page
19
of
38
8.1
RECEIPT AND INSPECTION
Upon receipt of the lift carry out the following checks:
- Check whether the delivery agrees with the order specifications and to the transport document.
- Make sure the packaging is undamaged and that no parts are damaged or broken during transport.
- Carefully inspect that the machines have not been damaged during transport or that some parts have
not been removed or tampered with.
- Check the presence of the enclosed documentation required for the installation phase.
IN THE EVENT OF NON-COMPLIANCE WITH THE ABOVE
SPECIFICATIONS, IMMEDIATELY NOTIFY THE
MANUFACTURER.
8.2
STORAGE AND STOP OF THE LIFT
In case the lift is not used, it will be necessary to proceed as follows:
- Store indoors in a place sheltered by weather conditions.
- All electrical / electronic equipment must remain packed in order to be protected against moisture.
- The temperature of the place of storage must be b5 ° C and +50 ° C.
- All parts with sliding (guides, cylinders ...) must be protected against dust and oxidation.
- The storage time is good does not exceed 6 months. In case of storage for longer periods, it is recommended
before proceeding with operating the machine, to contact the manufacturer for inspection of the conditions of the
lift.
THE STORAGE OF THE LIFT IN AREAS THAT
DO NOT CORRESPOND TO WHAT SPECIFIED,
WILL VOID THE WARRANTY FOR PARTS TO
BE REPLACED.
8.3
TRANSPORT
The transport of the lift must be effected through a vehicle (van, truck, etc..) with suitable size and capacity.
The lift is dispatched by the manufacturer packed in
carton box or wooden case fixed to a wooden or
plastic pallet.
The size of the package does not exceed 1635 x 875 x
1820 mm and the total weight of the package with the
lift does not exceed 400 kg.
