Bedpan / Urinal Bottle and Utensil / Bowl Washer Disinfector (WDS)
Operation, Maintenance and Installation Manual
Issue 16
Page
25
August 22
4.1
Detergent Warnings
First Warning
When last full segment is showing,
‘
LOW DETERGENT
’ will flash (there is approx. 1.5 to 1.6 litres in bottle)
Second Warning
When no full segments are showing
‘
EMPTY DETERGENT
’
will flash, there is approximately 750mL to 1litre in bottle
Third warning
Fault 302 - detergent time out (no detergent in bottle)
When full bottle is installed the detergent line will require purging (see 5.7)
FAULT 302
4.2
Fault Indication
In the event of a failure during cycle the device will go into fault. The display will show the selected cycle the device was
operating in when the failure occurred along with a fault code corresponding to the cause of the fault. Access to the load
will not be allowed until the cause of the fault has been fixed and a cycle has been successfully completed. Please refer to
the Fault Codes section of this manual for a description of the fault code displayed.
FLT XXX
flashing
Audible Buzzer will beep
After fault has been rectified a Purge/Reset will be required to reset the device (see
5.9)
. On completion of the “Purge Reset” device will restart previous cycle and will
not allow access to the load until cycle has been successfully completed.
FAULT XXX
FAULT 302
