13
Voltage
220-240V AC, 50Hz
Max. power
Incandescent/halogen 1000W, fluorescent lamp 300W, LED 150W
Detection area
180° horizontal, up to 10 metres
Duration time
From (10+5) seconds up to (4+1) minutes adjustable
LUX control level
From daylight to night adjustable
Protection class
IP44
SPECIFICATIONS
SETTING THE CONTROLS
1. Put the LUX control knob to light ( ) position, turn the wall switch on and wait half
a minute for the control circuit to stabilize. At this stage ensure that the TIME control
knob is set at minimum duration time (–) position (rotating the TIME knob clockwise
to stop position). The load light will now switch on and remain on for about 30 sec-
onds (within 60 seconds).
2. Direct the sensor towards the desired area to be scanned by adjusting the swivel
joint on the sensor arm.
3. Have another person move across the centre of the area to be scanned and slowly
adjust the angle of the sensor until the unit sensors the presence of the moving per-
son, causing the load light to switch on.
4. Adjust time control to required setting.
5. To set the light level at which the load light will automatically switch on at night,
turn the LUX control knob from daylight ( ) to night ( ). If the load light is required
to switch on earlier, e.g. at dusk, wait for the desired light level, then slowly turn the
LUX control knob towards daylight while someone walks across the centre of the
area to be detected. When the load light switches on, release the LUX control knob.
You may need to make further adjustments to achieve your ideal light level setting.
IMPORTANT
1. To avoid dust build-up and ensure proper functioning of the PIR Sensor, please wipe
the sensor lens lightly with a damp cloth every 3 months.
2. NEVER modify the unit, there are no user serviceable parts inside.
3. All Passive Infra Red (PIR) sensors are more sensitive to cold and dry weather than
warm and wet weather.
Summary of Contents for 99 190 17-18
Page 15: ...15...
