15
APPLICATIONS
The machine is intended to drive in and loosen screws.
CHARGING BATTERIES
The charger may become slightly warm while charging, but this does not affect its perfor-
mance.
1. Plug the charger jack into the charging socket firmly, and the charging indicator (3)
turns on. Allow 3 to 5 hours for battery to become fully charged.
2. When the charging is complete, remove the charger jack from the charging socket,
and also disconnect the charger from wall outlet.
Note:
1. It is normal for the handle of the tool to warm up slightly during the charging.
2. Disconnect the charger from the socket when not in use it.
3. The battery is protected against deep discharging. When the battery is empty, a pro-
tective circuit automatically switches off the tool. Charge the battery when the tool
is not run.
MOUNTING BIT (fIG.1)
Insert the driver bit (1) directly into the hexagon collet (2).
TRIGGER (fIG.2)
This tool is started and stopped by pressing and releasing the trigger (6).
This tool is equipped with a LED work light (7) to illuminate work area. LED is lit by press-
ing the trigger.
LED TORCH (fIG.3)
To turn on the LED torch (8), set the torch on-off switch (9) in the ON position. Turn off
the torch when not in use.
SPINDLE LOCKING
The spindle (hexagonal collet) is locked when trigger is not squeezed.
This enables screws to be screwed in or unscrewed by hand.
OVERLOAD PROTECTION
This tool is equipped with the overload protection circuit to avoid causing the damage to
the tool and the battery. When being loaded over 3.5Nm torque, the tool stops even if
the trigger is pressed.
MAINTENANCE
After use, check the tool to make sure that it is in top condition. It is recommended that
you take this tool to a Authorized Service Center for a thorough cleaning and lubrication
at least once a year.
